FOLIATEC HARD ROCK LINER 2K TEXTURED PAINT BLACK, AEROSOL 400ML

Foliatec Hard Rock Liner 2K textured paint is ideal for giving parts an aggressive and unique look. This textured paint is very hard, scratch resistant and therefore very chemical and temperature resistant. The Hard Rock Liner 2C textured paint in a 2C aerosol can is ideal for spraying small parts, rims, side mirrors or bumpers.

Foliatec Hard Rock Liner 2C textured lacquer uses an innovative 2-component system: the hardening agent is already in the can, which means you can say goodbye to the tricky mixing! Just pierce the cartridge of the hardening agent with the push button, shake, and you're done!



The texture depends on the distance between the spray can and the surface. This allows you to determine the structure, the closer you apply the paint to the surface, the coarser the structure. If you want a fine structure then keep the spray can at a greater distance from the surface, very simple!


Characteristics:

- Textured black lacquer

- Aggressive appearance

- Variable structure

- Extremely robust and scratch resistant

- Highly chemical and temperature resistant

- Ideal for spraying small parts such as rims, side mirrors or bumpers

- Content: 400ml



Instructions for use:

1) Sand the surface

2) Clean and dry the surface to be sprayed, then degrease.

3) Apply the Hard Rock Liner in 2 spray layers, spray distance approx. 70 - 110 cm.



Drying time: leave 5 - 10 minutes between each coat.

After 60 - 70 minutes, the Hard Rock Liner is touch proof and must be allowed to dry further for approx. 24 hours at 20°C.

For detailed information, refer to the instructions for use.



Preparation of the 2C spray can:

1) Shake canister well before use. Remove the red push button from the cap immediately before spraying.

2) Turn canister 180° and attach red push button to pin on bottom of canister.

3) With the ball of your hand, press the red push button as far as possible. Shake the can again well after activation.

4) The can is now ready for use!

Note: After activating the hardener, the processing time of the can is approx. 1.5 hours / 20°C.