TYCO COOLSEAL CONNECTOR RED (50PCS)

Cold-applied waterproof and insulated connectors

About Cool Seal

The Cool Seal product range is a new and innovative alternative to heat shrinking connectors. Cool Seal provides a high quality moisture protected electrical connection that gives time and money saving benefits. You can easily apply Cool Seal by stripping the wire ends, inserting the wire ends through the gel in the connector and squeezing the connector. After this, the patented gel will be activated immediately creating a top quality waterproof electrical connection!
You no longer need a burner or f;hn to make a high quality electrical connection. Cool Seal can be applied in engine compartments, chassis and lighting systems in the automotive sector, construction, lighting industry and marine aviation, among others.

Benefits and technical properties

-;Non-shrink and solderable waterproof connection.-;Patented gel protects the connection from environmental influences such as moisture and salt.-;Simple operation: strip the wire and squeeze the connector.-;Complies with EU directives 2002/61/EC, 2003/34/EC, 2002/95/EC, 2003/36/EC, 2003/11/EC and RoHS.-;UL/CSA listed.-;Can be installed in a fraction of the time compared to heat shrinking connectors. -;Depending on application and situation, time savings of over 80% can be achieved.-;Increases productivity and saves labor costs.-;Provides a safer working environment - No burner or f;hn needed.-;Nylon jacket provides excellent protection against abrasion in the harshest environments and conditions.-;Available in three AWG sizes: 22-18GA (red), 16-14GA (blue) and 12-10GA (yellow).-;99.9% electrolytically oxygenated copper connector for a reliable, high quality electrical connection.-;Tensile strength meets and exceeds EN 60352-2 standard when properly applied.

How to use the cool seal

Step 1 - Strip wire ends.Step 2 - Insert wire ends through gel into the connector.Step 3 - Tighten copper connector left and right. Tip! Step 4 - After squeezing both sides of the connector, the gel is activated immediately.Within 2-3 hours, the gel is 80% cured, after 48 hours it is fully cured.Wait preferably 3 hours before putting intensive stress on the Cool Seal connection
.